Properties of Solids & Liquids (NEET (NTA)National Eligibility cum Entrance Test (Medical) Physics): Questions 160  164 of 190
Visit this page to view all the question topics
To view these problems with solutions proceed here and click "Subscribe Now".
Question number: 160
» Properties of Solids & Liquids » Specific Heat Capacity
Question
A beaker contains 400 gm of water. The heat capacity the beaker is equal to that of 20 gm of water. The initial temperature of water in the beaker is 20°C. If 240 gm hot water at 92°C is poured in it, the final temperature (neglecting radiation loss) will be nearest to
Choices
Choice (4)  Response  

a.  12.58°C 

b.  46.18°C 

c.  6.348°C 

d.  73.4°C 

To view these problems with solutions proceed here and click "Subscribe Now".
Question number: 161
» Properties of Solids & Liquids » Surface Energy and Surface Tension
Question
Radius of a capillary tube is 4 × 10 ^{3} m. A liquid of weight 5.20 × 10 ^{4} N may remain in the capillary tube then the surface tension of liquid will be
Choices
Choice (4)  Response  

a.  2.3 × 10 ^{2} N/m 

b.  20 N/m 

c.  2.0 × 10 ^{2} N/m 

d.  20 × 10 ^{3} N/m 

To view these problems with solutions proceed here and click "Subscribe Now".
Question number: 162
» Properties of Solids & Liquids » Heat Transfer » Convection
Question
When fluids are heated from the bottom, convection currents are produced because
Choices
Choice (4)  Response  

a.  Heated fluid becomes less dense than the cold fluid above it 

b.  Molecular motion of fluid becomes aligned 

c.  Heated fluid becomes more dense than the cold fluid above it 

d.  Molecular collisions take place within the fluid 

To view these problems with solutions proceed here and click "Subscribe Now".
Question number: 163
» Properties of Solids & Liquids » Young's Modulus
Question
For a given material, the Young’s modulus is 2.4 times that of rigidity modulus. Its Poisson’s ratio is
Choices
Choice (4)  Response  

a.  2 

b.  0.2 

c.  1.02 

d.  1.2 

To view these problems with solutions proceed here and click "Subscribe Now".
Question number: 164
» Properties of Solids & Liquids » Elastic Behavior
Question
The ratio of radii of two wires of same material is 4: 1. If these wires are stretched by equal forces, then the ratio of stresses produced in them will be
Choices
Choice (4)  Response  

a.  1: 4 

b.  1: 16 

c.  2: 1 

d.  4: 1 

To view these problems with solutions proceed here and click "Subscribe Now".