Properties of Solids & Liquids (NEET (National Eligibility cum Medical Entrance Test) Physics): Questions 107 - 111 of 190

Visit this page to view all the question topics

To view these problems with solutions proceed here and click "Subscribe Now".

Question number: 107

» Properties of Solids & Liquids » Elastic Behavior

MCQ▾

Question

The force required to separate two glass plates of area 10 -2 m 2 with a film of water 0.05 mm thick between them, is (Surface tension of water is 70 × 10 -3 N/m)

Choices

Choice (4) Response

a.

50 N

b.

14 N

c.

28 N

d.

38 AT

To view these problems with solutions proceed here and click "Subscribe Now".

Question number: 108

» Properties of Solids & Liquids » Heat Transfer » Convection

MCQ▾

Question

Two rods A and B are of equal lengths. Their ends are kept between the same temperature and their areas of cross-sections are A 1 and A 2 and thermal conductivities K 1 and K 2. The rate of heat transmission in the two rods will be equal, if

Choices

Choice (4) Response

a.

Equation

b.

Equation

c.

Equation

d.

Equation

To view these problems with solutions proceed here and click "Subscribe Now".

Question number: 109

» Properties of Solids & Liquids » Terminal Velocity

Assertion-Reason▾

Assertion (Ꭺ)

Bernoulli’s theorem holds for incompressible, non-viscous fluids.

Reason (Ꭱ)

The factor Equation is called velocity head.

Choices

Choice (4) Response

a.

Both Ꭺ and Ꭱ are true but Ꭱ is NOT the correct explanation of Ꭺ

b.

Ꭺ is false but Ꭱ is true

c.

Both Ꭺ and Ꭱ are true and Ꭱ is the correct explanation of Ꭺ

d.

Both Ꭺ and Ꭱ are false

To view these problems with solutions proceed here and click "Subscribe Now".

Passage

Read the passage given below and answer the questions that follows:

In a thermally insulated tube of cross sectional area 4 cm 2 a liquid of thermal expansion coefficient 10 -3 K -1 is flowing. Its velocity at the entrance is 0.1 m/s. At the middle of the tube a heater of a power of 10 kW is heating the liquid. The specific heat capacity of the liquid is 1.5 kJ/ (kg K), and its density is 1500 kg/m 3 at the entrance.

Question number: 110 (1 of 3 Based on Passage) Show Passage

» Properties of Solids & Liquids » Thermal Expansion

MCQ▾

Question

How much bigger is the volume rate of flow at the end of the tube than at the entrance in cubic meters?

Choices

Choice (4) Response

a.

Equation

b.

Equation

c.

Equation

d.

None of the above

To view these problems with solutions proceed here and click "Subscribe Now".

Question number: 111 (2 of 3 Based on Passage) Show Passage

» Properties of Solids & Liquids » Thermal Expansion

MCQ▾

Question

What is the density of liquid at the exit?

Choices

Choice (4) Response

a.

Equation

b.

Equation

c.

Equation

d.

None of the above

To view these problems with solutions proceed here and click "Subscribe Now".